beveling उदाहरण वाक्य

CAPTION : Beveling edges of patch to fit beveled edges around hole in wall makes it easy to set patch in place with joint cement.
It was expected to adopt the common form of rail, beveling the edges of the lower stringers and placing the rail at an angle of about 45 degrees.
The reference flat is slightly beveled ( only a fraction of a degree of beveling is necessary ) to prevent the rear surface of the flat from producing interference fringes.
Beyond trigger work, more sophisticated modifications include replacing the stock hammer and sear with lightweight components, installing a high quality spring set and beveling the inside of the ejection port.
The joint is often formed to allow space for the flux to flow out, by beveling or rounding the surfaces slightly, and hammered in a successively outward fashion to squeeze the flux out.

Grass of " L . inebrians " is harvested during the flowering period, beveling it with sickles, or by cutting it with shears at a height of about from the ground.
Other great rod makers worked there as well : F . E . Thomas, E . F . Payne, Fred Devine, George Varney, Hiram Hawes and Loman Hawes with whom Leonard developed his revolutionary beveling machine.
Mrs . Strong's bespoke products display a range of crafts which are rarely used by others in the industry, including hand engraving of dies in steel, hand-stamping of dies, hand-mixing of custom varnish inks, hand-beveling and bordering, and hand-lining of envelopes.
The cards of " Revised " like the cards of the preceding " Unlimited Edition " all had white borders, no expansion symbol, and the artist credit at the bottom left . However, the cards were far paler than their " Unlimited " counterparts, and the three-dimensional beveling of the cards was cropped out.
Beveling is almost never done with Fillet Welds ( weld in a corner ) but as you can see from the'Crucifix Weld'shown above that for thicker plate a double-Bevel permits full penetration of each weld to the other ( removing a possible void space in the center ) eliminating any source of failure ( IF the Weld is made correctly ).