hold circuit उदाहरण वाक्य

उदाहरण वाक्य

1. A single digital-to-analog converter ( DAC ) was shared by all six ports providing voltage compare functions for the modulators and feeding sample and hold circuits for the demodulator outputs.
2. Digital phase detectors can also be based on a sample and hold circuit, a charge pump, or a logic circuit consisting of pull-in range in comparison to an XOR detector.
3. These time values are important, for example, when a capacitor is used as timing component for relays or for storing a voltage value as in a sample and hold circuits or operational amplifiers.
4. Dielectric absorption may be a problem in circuits where very small currents are used in the function of an electronic circuit, such as long-time-constant integrators or sample-and-hold circuits.
5. "Analog discrete-time signal processing " is a technology based on electronic devices such as sample and hold circuits, analog time-division multiplexers, analog delay lines and analog feedback shift registers.
6. The sample-and-hold circuit freezes the voltage applied to the z piezo, which freezes the tip-sample distance, at the desired location allowing I-V measurements without the feedback system responding.
7. These time constants are always relevant if capacitors are used as time-determining elements ( such as timing delay ), or for storing a voltage value as in sample-and-hold circuits or integrators.
8. He wrote the other justices, " I am not of opinion that we can under our present appointments hold circuit courts, but I presume a contrary opinion is held by the Court and, if so, I shall conform to it ."
9. A typical sample and hold circuit stores electric charge in a capacitor and contains at least one switching device such as a volatile, but the loss of voltage ( " voltage drop " ) within a specified hold time remains within an acceptable error margin.
10. Opto-isolators using field-effect transistors ( FETs ) as sensors are rare and, like vactrols, can be used as remote-controlled analog potentiometers provided that the voltage across the FET's output terminal does not exceed a few hundred mV . Opto-FETs turn on without injecting switching charge in the output circuit, which is particularly useful in sample and hold circuits.